New Wireless Remote Tuner for Midi Controlled Pipe Organs.
The New "Wireless Remote Tuner" enables the pipe organ tuner to remotely turn ON and OFF each note in a rank without the assistance of a KEY HOLDER sitting at the console. A small Radio/MIDI receiver is located at the console and connected to the MIDI IN port of a MIDI interface or MIDI controlled console. Select the MIDI Channel for a keyboard input and turn on the stop for the rank to be tuned. With some MIDI systems, the Stops can also be selected. Check out the many features of the new Wireless Remote Tuner.
Features
Features
- Single person tuning, no key holder required.
- Wireless functions up to 400 ft.
- Midi Control.
- Small Size.
- Battery powered.
- Select Octave or Two Octave for Octave tuning.
- Midi Channels 1 to 16.
- Works with Hauptwerk controlled Pipe Organ.
- Works with Artisan and Peterson Midi systems.
IDC-48 All in One 48 Note MIDI Encoder/Decoder-Stop Action Driver
Introducing the NEW Single Board IDC-48 Midi Encoder/Decoder-Driver for Draw Knobs and SAM's. The IDC-48 can control up to 48 Stop Actions and sense the Stop Actions switches, sending and received midi data to and from Hauptwerk. The single board configuration eliminates stop action wiring to a separate midi encoder and midi decoder location. Other Features include "Auto Pulse Length" which will supply voltage to the action coils for up to 500ms or as short as needed based on the action switch movement. The Smart Action function will send voltage to a stop if the stop is set to change in the combination action and TEST MODE that steps the actions in sequence make the IDC-48 an ideal choice.
LPC-1, Lighted Piston Controller
The New LPC-1 Lighted Piston Controller will control up to 12 piston lamps. The pistons can be either General Pistons or Division Pistons per card. Each piston wil send an individual midi note on an assigned midi channel, based on the Midi Note and Midi Channel DIP Switch selection. There are no configuration files to create or computer programming to configure the LPC-1. Midi In, Midi Out and Midi Through are supported and all functions are controlled through an on board crystal controlled microcontroller. The LPC-1 offers the simplest solution for Lighted Pistons and Hauptwerk.
DC-96 Multi Function Midi to 96 Output Driver Card
Introducing the DC-96 Midi Decoder/Driver Card.. The DC-96 Multi Function Midi Driver card can be set to control Lamps, Stop Actions and Pipes through simple DIP Switch settings and all from Hauptwerk. No configuration files or programming files required. The DC-96 is available in either Positive switching (Common Ground) or Negative Switching, (Common Positive).
The DC-96 is designed with a crystal controlled micro controller for the utmost stability. Powering the DC-96 requires a single 12 volt DC supple, no separate 5 volt supply required.
For that next VPO console conversion, consider the DC-96 Midi Driver Card.